CG0198

CloudGate 3G Americas Rev 3

Model: CG0198

 


Quickstart Guide

Click here to download the Quickstart Guide of the CloudGate 3G Americas Rev 3.

 


Canada

The CloudGate 3G Americas Rev 3 (CG0198) can be used in Canada and complies with the applicable Industry Canada regulations.

 

The product completed PTCRB certification.

 

The CloudGate 3G Americas Rev 3 (CG0198) CANNOT be used in Class I Div 2 Hazardous Locations.

 

 

INDUSTRY CANADA REGULATIONS

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

 

External antennas

Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.

 

This radio transmitter, IC 7830A-PXS8, has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.

To comply with Industry Canada regulations limiting both maximum RF output power and human exposure to RF radiation, maximum antenna gain must not exceed:

  • 3.92 dBi in Cellular band (850MHz)
  • 2.51 dBi in PCS band (1900MHz)

 

In addition the product shall be installed in a way that a distance of at least 20 cm is maintained between the antennas and the user’s body.

 

REGULATIONS INDUSTRIE CANADA

 

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

 

Antennas externes

Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risqué de brouillage radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.

 

Le présent émetteur radio, IC 7830A-PXS8, a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur.

  • 3.92 dBi dans la bande cellulaire (850MHz)
  • 2.51 dBi dans la bande SCP (1900MHz)

 

En plus, le produit doit être installé de manière à assurer une distance de séparation de 20 cm minimum entre le corps de l’utilisateur et les antennes.


United States

The CloudGate 3G Americas Rev 3 (CG0198) can be used in the USA and complies with the applicable FCC rule parts.

 

The product completed PTCRB certification and has been approved by the following network operators:

  • AT&T
  • Verizon Wireless

 

The CloudGate 3G Americas Rev 3 (CG0198) CANNOT be used in Class I Div 2 Hazardous Locations.

 

 

FCC REGULATIONS

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
 

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

 

Federal communications commission notice

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

 

Exposure Information to Radio Frequency Energy

Users concerned with the risk of Radio Frequency exposure may wish to limit the duration of their calls and to position the antenna as far away from the body as is practical.

 

Modifications

Any changes or modifications made to this device that are not expressly approved by Option could void the user's authority to operate the equipment.

 

External antennas

To comply with FCC regulations limiting both maximum RF output power and human exposure to RF radiation, maximum antenna gain must not exceed:

  • 3.92 dBi in Cellular band (850MHz)
  • 2.51 dBi in PCS band (1900MHz)

 

In addition the product shall be installed in a way that a distance of at least 20 cm is maintained between the antennas and the user’s body.